pbjunky99
06-20-2009, 10:00 PM
Ok I looked in the ULT thread and found some one that had the same problem I have but noone gave a solution so here we go.
1. My mag is leaking from the ULT. I have swaped all the o rings and it wont stop.
2. My trigger sticks quit offen. I have tried adding and removing shims but it dosnt help. After a few shots (any where form 2-20) it will stick back and not move forward again. This happens in single shot and rting.
3. Noticed that when I add/remove shims that the ULT dosnt tighten upnot sure if that right or not.
4. Level 10 dose stick at times but resets properly when I test it.
Set Up
X valve
ULT? w 6 shimms
Level 10 factory set
1. My mag is leaking from the ULT. I have swaped all the o rings and it wont stop.
2. My trigger sticks quit offen. I have tried adding and removing shims but it dosnt help. After a few shots (any where form 2-20) it will stick back and not move forward again. This happens in single shot and rting.
3. Noticed that when I add/remove shims that the ULT dosnt tighten upnot sure if that right or not.
4. Level 10 dose stick at times but resets properly when I test it.
Set Up
X valve
ULT? w 6 shimms
Level 10 factory set