SledgeHammer LPR NEED HELP PLZ!

[Danielkong916]

2nd Generation SledgeHammer(What Im Working W/)
http://i637.photobucket.com/albums/uu94/hmcl110/customcockers/4-20-09/pneum/DSC02087.jpg



Hey guys i am working on putting a pneumag together and was curios if you can unscrew the 1/8 thread in the bottom of a sledge hammer and replace it w/ a 90 degree swivel (like in picture) Trying to place an order tonight so it can get shipped tomorrow any quick help is VERY much appreciated. Thanks in advance!
-Dan

http://www.iisports.com/assets/images/product/iispaintball/Large_Photos/Xp9956a-s.jpg

[Spider-TW]

I'm pretty sure you will have to add the 90 to the existing 1/8 npt. If it is the same as a tickler, the body threads are straight and there is an o-ring on the outside and the fitting is drilled out for the pin spring, so you really can't go without the fitting that comes on it.

[Danielkong916]

Ok cool good to know i already ordered a extra 90* NPT I found something that could clean it up a bit for people also looking to do this. (thank god i live down the street from palmers!)
FEMALE TO FEMALE! gotta love the girl on girl! This is going to solve my problems hope it helps others out too!

http://www.palmer-pursuit.com/cart/index.php?main_page=product_info&cPath=10&products_id=12

-Dan