View Full Version : Barrel shroud
Ebbed
07-19-2009, 09:22 PM
I own a barrel kit with a 6” control sections that are polished albumin. I want to find a shroud that will conceal the aluminum control section ASWELL as protect it. All the shrouds I find on the net attach to the barrel itself, I’d rather not use a shroud if it connects in this fashion. I was wondering is anyone knows of a shroud that mounts onto site rails that will not make any contact with the barrel.
BenoitOWN
07-19-2009, 09:55 PM
Add a delrin sleeve?
wetwrks
07-19-2009, 10:51 PM
I haven't seen any made to do that. You could probably make or modify one to do that.
In theory you could use a ghetto method of set screwing it in : Give the section the set screws are pressing into a few layers of duct tape.
polished albumin
:confused:
http://www.artistshelpingchildren.org/kidscraftsactivitiesblog/wp-content/uploads/2009/04/blowing-egg.jpg
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.