xvalve with L7

[ezcreation]

Alright I dont know why but where I am it seems that I need to retune my L10 (larger carrier) too often so I have decided to simply install a L7 on my xvalve. It shoots awesome I must admit, insanely stable!

The only weird stuff is that below 1000psi it goes nuts...I used to be able to go as low as 600psi on my previous L10 set-up.

Anyone would know why?

[Tym]

L7 Bolt on an Xvalve??

Did you take out the carrier and o-ring and shims too? Or just the bolt?

One thing you have to remember is, when breaking in a carrier o-ring (it takes Many bags of paint) it is not at all uncommon to have to change the carrier and shims as the o-ring wears in..
As the o-ring wares in you may have to change the carrier out, or add shims.. Sometimes MANY times... Once it's broken in it should be fine..

[ezcreation]

Yep
Basically you replace all L10 part with the L7 and it shoots very very nice

Trust me on the L10 I have tried on sveral valves and they all do the same

[TwilightG]

The only weird stuff is that below 1000psi it goes nuts...

What does it do? :confused:

[ezcreation]

It chockes and puffs like there is not enough pressure to seal the L7