DocRocker
08-17-2009, 02:11 PM
Hey all,
So I was taking apart my PMI regulator (reactor II valve) bc it started leaking between the bonnet and base. Well the regulator oring was shreaded. Ok that seems easy enough to fix.
My questions are:
1. Do you have to oil anything in there? There appeas to be some rust on the piston and bellvele spring pack. Dont know if oil is needed. Always heard its bad for the fill nipple but this the output side only so I dont think it matters as much.
2. Most importantly. The drawings of the regulator shows that the regulator seat looks like a round ball.
http://paintballsolutions.com/05pb_solutions/pdf/manuals/pureenergy/PE_manual.pdf
When I took my reg apart, I didnt see this ball. Either I lost the piece and didnt notice or its something else. has anyone who has taken apart their regulator seen what the regulator seat looks like?
Thanks
So I was taking apart my PMI regulator (reactor II valve) bc it started leaking between the bonnet and base. Well the regulator oring was shreaded. Ok that seems easy enough to fix.
My questions are:
1. Do you have to oil anything in there? There appeas to be some rust on the piston and bellvele spring pack. Dont know if oil is needed. Always heard its bad for the fill nipple but this the output side only so I dont think it matters as much.
2. Most importantly. The drawings of the regulator shows that the regulator seat looks like a round ball.
http://paintballsolutions.com/05pb_solutions/pdf/manuals/pureenergy/PE_manual.pdf
When I took my reg apart, I didnt see this ball. Either I lost the piece and didnt notice or its something else. has anyone who has taken apart their regulator seen what the regulator seat looks like?
Thanks