New to E-mag

[foodboy]

I'm putting together my first e-mag from lowers I just bought here on AO.

I'm quite familiar with mags but not the e-mag so I have a few questions.

1-The X valve I am going to use has the ULT and was previously used with a Y grip.
will this work at all? Do I just replace the pin or the whole on/off.

2-Where can I find info on AGD3.2 (the emag manual PDF refers to an earlier version I think)

3-Other than the usual O rings for the valve what back up parts should I order that are E-mag specific?

4-How long does the battery take to charge. Is it the same with a car charger vs wall adapter?


Thanks for your help

Foodboy

[kwood]

you can not use a ULT
you will need to find yourself an emag on/off assembly
the pin length is different
i dont know specifically off the top of my head what the length is but you can find them in the AGD store
some one else chime in here on some details

[211]

.712 on/off pin
any RT style on/off will work

[Beemer]

4-How long does the battery take to charge. Is it the same with a car charger vs wall adapter?
Thanks for your help

Foodboy

While the battery is charging the light on the charging unit will appear red. The light will change to green when it is in trickle charge mode; trickle charge mode occurs when the battery is about 85-90% charged. At this point, the battery is ready for play. Trickle charge an additional 3-4 hours, if desired, to attain 100% charge.
Some batteries may cause the green light to come on in a few minutes. Continue to trickle charge for several hours for a full charge.

[foodboy]

Thanks for the help so far.
:)

[Little_Ho]

he got som information about AGD3.2 and more on his page

http://www.niedtech.com/index.php

[Looper]

.712 on/off pin
any RT style on/off will work
You should also get the quad o-ring for the top of the on/off.

http://store.airgundesignsusa.com/index.cfm?fuseaction=catalog.prodInfo&productID=195&categoryID=24
http://store.airgundesignsusa.com/index.cfm?fuseaction=catalog.prodInfo&productID=205&categoryID=24