Old warp i need parts updates!!!

[i-luv-my-rt]

I just ordered the plastic diverter plate but it still jams and wont push the balls. I have intellifeed and i can see the warp motor spinning. Sometimes there wont be paint in it and it wont spin right. Any help would be good. Thanks!!!

[Dubstar112]

Is the drive belt slipping on the brass wheel? Ive seen this happen, and if the warp is real old the belt may be worn out a little bit.

[i-luv-my-rt]

I just ordered a couple of the pulley o-rings. That should help. I think??