Idea for a magnetic trigger return

[Ebbed]

Been thinking of a way to make a magnetic return for my trigger how well do you guys think this would hold the magnets to the back side of the trigger/ frame?

http://www.shopatshowcasecanada.com/superputty.html

http://www.radioshack.com/product/index.jsp?productId=2102642

[xero28]

I've used those magnets from Radio Shack on a Pneumag before, work fine. I've been thinking about doing the same thing, but maybe drilling a small pit into the back of the trigger and the frame then filling that with super glue and dropping the magnets in. Though I just got a Viperblade trigger to use with my cheater, and pulling the trigger back as far as it goes the trigger is still about 1/8"-1/4" away from the frame, I don't think putting magnets there would benefit anything. I'm thinking that since there is a trigger stop on the top of the trigger as well, I can drill a pit in the top of the trigger frame right above the stop. I'd stop the pit JUST before it breaks through and the drop a couple/three magnets into the pit, this would draw the stop screw back, instead of using two magnets to oppose each other. Similar to triggers on other electros. (E-blades for example.) Though, considering the trigger pull on it right now is less than 1mm, I'm really not sure anything could make it any better.