druid
11-10-2009, 06:19 PM
Ok. I want to make my Warp feed feed from a higher voltage and need advice on how to procede...
The board can take 12V without an issue. It comes stock running on one 9V battery.
To make it 12V, they say to wire two 9V batteries but dumb it down with a 12V resistor.
How do I do this?
I know it's black-to-red............red-to-black.......to join the 2 9Volts into the one [that is attached to the board] but how/where do I wire what 12V resistor and what kind do I get??
If you can find the items on Radio Shack's website and link me to them, I'd appreciate it.
Diagrams on how to do this are also a plus......lol.
The board can take 12V without an issue. It comes stock running on one 9V battery.
To make it 12V, they say to wire two 9V batteries but dumb it down with a 12V resistor.
How do I do this?
I know it's black-to-red............red-to-black.......to join the 2 9Volts into the one [that is attached to the board] but how/where do I wire what 12V resistor and what kind do I get??
If you can find the items on Radio Shack's website and link me to them, I'd appreciate it.
Diagrams on how to do this are also a plus......lol.