View Full Version : Question for Solidworks users.
Is it possible to save a part without the background page? I designed a new logo I want to use on my website, but I only want the “part” not the page. Not sure if that makes sense, if not LMK.
Does anyone know how to change the back ground color of the page?
Smoothice
11-24-2009, 08:29 PM
i know nothing about solid works.
Is the logo a separate layer or is it part of the background?
MoeMag
11-24-2009, 11:19 PM
Try this first...
http://i33.photobucket.com/albums/d53/MoeRoark/bg1.jpg
Then if that doesnt work go to... Tools > Options
http://i33.photobucket.com/albums/d53/MoeRoark/number2.jpg
Hope that works. If not LMK!
:cheers:
Another question, how do I get rid of the white parts of my drawings? I've tried to select them individually but the program won't allow it. Is there anyway to clean it up?
http://www.lukescustoms.com/Page22_Picture_Host/lclogo%20ex.jpg
http://www.lukescustoms.com/Page22_Picture_Host/lclogo%20ex%20loom.jpg
MoeMag
11-25-2009, 04:49 PM
Thats a preformance issue. You might be able to go to= Tools>options> system options tab>preformance>curvature generation and set that higher.
Other than that look into a graphics card.
...unless you modeled your curves with straight lines. :tard:
Thats a preformance issue. You might be able to go to= Tools>options> system options tab>preformance>curvature generation and set that higher.
Other than that look into a graphics card.
... :tard:
Thanks, That did it! Damn your good. :cheers:
unless you modeled your curves with straight lines.
Nope :)
Where is the lighting control?
I've seen it before but don't remember where.
MoeMag
11-25-2009, 08:45 PM
http://i33.photobucket.com/albums/d53/MoeRoark/lights.jpg
Red ellipse this time.
Click on it and it will open up the lights. It has an ambient and two spots usually. You can position the spots, and add more I believe.
Select each light and you can manipulate its position, color, and intensity.
http://i33.photobucket.com/albums/d53/MoeRoark/lights.jpg
Red ellipse this time.
Click on it and it will open up the lights. It has an ambient and two spots usually. You can position the spots, and add more I believe.
Select each light and you can manipulate its position, color, and intensity.
Damn that was right under my nose, it's been awhile since I used this program. Thanks for the help. :cheers:
Thanks for the help wouldn't have it finished up without your help. :cheers:
Here's one of the finished projects, much better than what I had. (Header for my website)
http://www.lukescustoms.com/Buttons/lukes%20customs%20logo%20with%20plate.jpg
MoeMag, is there anyway to "tilt" a part by "single axis" using mathematical input? (Without using the “Rotate View” button)
I got it, never mind. :cheers:
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.