View Full Version : ? about ULE body on magpump
crawler24
01-03-2010, 06:51 PM
i am redoing my magpump. i bought a ULE body and have a place to mill it. will i have problems with the pump handle fitting the ULE front that overhangs the rail? i bought a minimag body, and it was too tight to use it. thanks
automagmasta
01-03-2010, 09:25 PM
should work fine
Smoothice
01-03-2010, 09:29 PM
I had to sand down my pump handle to fit on my minimag body.
Kind of a pain but worth it.
http://i187.photobucket.com/albums/x57/smoothice15/socal-wavecopy.gif
crawler24
01-04-2010, 12:18 PM
it doesnt look like there is much room to sand it, which is why i didnt use the minimag body. but the ULE are not much longer then the classic so i am being hopefull
crawler24
01-14-2010, 07:37 AM
looks like i have a clearnace issue w/the ULE body on the pump. has anyone sanded the handle to make them fit? it dosent look like much aterial there and i dont want to mess it up.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.