phizz
01-20-2010, 08:20 AM
hey guys I have almost got all my parts in to make a pumpmag but I was just looking at them and I have a quick question.
One of the rails I bought is not the standard rail with the angled sides, its flat like an emag rail on the bottom. With the pump kit that I am using with this will I have to mill off the slot and make it smooth to match or should is still work without having to mill?
One of the rails I bought is not the standard rail with the angled sides, its flat like an emag rail on the bottom. With the pump kit that I am using with this will I have to mill off the slot and make it smooth to match or should is still work without having to mill?