Warp Battery Question

[Badabing]

WOuld it be bad to run my warp on 18v? Cause I want to wire to 9v's together. Also, Whats the best jumper setup for spin length. And what do the jumpers do on the right side of the board?

Thanx

[BlackVCG]

Do not run anymore than 12V to the Warp. If you do, you risk frying the board. That's too much speed for pratical applications. At 9v's it will spin fast enough to keep up with anything shooting around 18bps.

Set your dwell jumpers to no more than two in the vertical position. This will feed reliably and conserve battery life. If your hopper isn't keeping up with the Warp and the rate at which your gun is shooting, then put more jumpers in the horizontal position. Doing so will cause the wheel to spin longer after your last shot and fill the gaps created by the hopper not keeping up.

[Badabing]

Thanx for the input, I'm gunna run a 9v paralell which i have researched a lil bit.

thanx
badabing

[BlackVCG]

Yes, those work fine.

[Scorch]

Are the AA battery harnesses still available?

Scorch

[BlackVCG]

The AA harness that uses 4 AA's for 6V's? I have one, but they don't make them anymore. Call AGD and see if they have any laying around.

[Shaft]

Originally posted by BlackVCG
Yes, those work fine.

Black... you've now let me down.... :(

On the bright side - I have completed my version of a 12v adapter - even had a PCB milled (for durability). It turned out real nice.