WarHamster
02-21-2010, 12:48 AM
In my on going attempt to mount Dye Sticky 3's (my preference in Grips) onto every marker I own, I managed to fit a pair onto my E-Mag.
I figured the screw holes on the spyder Sticky 3's would be close enough to work. Sadly I was wrong, but with a power drill and a hacksaw (or a dremel which does both in my case) you can correct this.
Just drill a hole slightly down and back from the top screw hole to line up with the E-mag, pick up some slightly longer frame screws from the hardware store, hack off a bit of the back top of each frame to make room for the safety and you're in business. You can even read the screen through the clear plastic and window on the grips!
Overall I couldn't be happier with the results!
http://i120.photobucket.com/albums/o192/WarHamsterII/EmagSticky1.jpg
http://i120.photobucket.com/albums/o192/WarHamsterII/EmagSticky2.jpg
I figured the screw holes on the spyder Sticky 3's would be close enough to work. Sadly I was wrong, but with a power drill and a hacksaw (or a dremel which does both in my case) you can correct this.
Just drill a hole slightly down and back from the top screw hole to line up with the E-mag, pick up some slightly longer frame screws from the hardware store, hack off a bit of the back top of each frame to make room for the safety and you're in business. You can even read the screen through the clear plastic and window on the grips!
Overall I couldn't be happier with the results!
http://i120.photobucket.com/albums/o192/WarHamsterII/EmagSticky1.jpg
http://i120.photobucket.com/albums/o192/WarHamsterII/EmagSticky2.jpg