Questions about 10 round tubes

[CatoRockwell]

Hey, will 10 round tubes fit right into a standard feedneck? Stupid question I know, but I've never used a 10 round tube in all my years of painball.

[maniacmechanic]

yes , but they are very , very loose

[fishmishin]

I have a 10rnd tube at work that I put some tape around to use to feed V-balls with, but it has a right decent amount of tape around it.

[CatoRockwell]

so what would you guys recommend to feed 10 round tubes directly? I have a warpfeed feedneck would it be better to use that?

[Ando]

I wouldn't recommend buying from these guys. Other sites have them.
http://cgi.ebay.com/Stock-Pump-Straight-10-shot-Stick-Feed-Tube-paintball_W0QQitemZ170447738414QQcmdZViewItemQQptZ LH_DefaultDomain_0?hash=item27af7a162e

[Hobbez]

You can build your own stick mag out of pvc parts pretty easy and cheap. A little pipe, an elbow, something for endcaps. Quick trip to Home Depot or Lowes. You can evan make it spring loaded if your good with a dremel.

If you buy one, buy from here (I always look here first now) or another site. I'd avoid iisports at all costs. I myself, and I know others her have, have had a lot of problems with them. I just got finished fighting with ebay cause they filled a complaint against me for not paying and I can prove 13 attempts to pay them and their checkout would say it took my payment and then spit out an error the next day, Cost me $13 in declined payment fees for no product and they got their listing fee back :mad:

[georgeyew]

I have a 3/4" copper fitting on my powerfeed neck. I was able to get a copper pipe cap from Home Depot and cut out the center for the 10 round tube to slide into. It works pretty well.

[athomas]

Use a short piece of 3/4" pvc conduit. The 3/4" opening will fit the feedneck of a standard or powerfed mag. You can make a 10 round tube fit the other end by heating the pvc and pushing the rounded end of the tube into the opening. Let it harden and remove the tube. Now you will be able to push the 10 round tube into the pvc pipe and it will hold it nice and snug. With different lengths of pvc pipe you can make different lengths of feed tubes. If you use a long 90 degree elbow, you can make a nice 25 round feed tube that curls up past your head without sticking out too far or getting in your field of view.

[rseb4agze]

I wouldn't recommend buying from these guys. Other sites have them.
http://cgi.ebay.com/Stock-Pump-Straight-10-shot-Stick-Feed-Tube-paintball_W0QQitemZ170447738414QQcmdZViewItemQQptZ LH_DefaultDomain_0?hash=item27af7a162e

I have this one on my pumpmag and works great :cheers:.. It drop right into my feedneck and clamp it on and fit like a glove.. I did cut it down a little to give it lower profile it's because I have no rise feedneck..

http://i283.photobucket.com/albums/kk282/rseb4agze/My%20automags/My%20Pump%20Mags/th_Picture124.jpg (http://s283.photobucket.com/albums/kk282/rseb4agze/My%20automags/My%20Pump%20Mags/?action=view&current=Picture124.jpg)

If you don't want to buy it from I&I sport you can get it here:
http://www.paintballgateway.com/wgppugun13ro1.html
Paintballgateway.com