MFM-70
05-04-2010, 07:07 PM
Looking for confirmation that I should do this upgrade:
I have checked my A.I.R. valve hole alignment from the regulator to the main body and found them to be misaligned by a little more than 1/3 of a turn when the valve is assembled and the logo etching matches up.
Should I:
1)Leave it alone?
OR
2) Drill a second hole in the regulator that aligns with the main body hole?
This to improve flow and reduce shootdown.
I run Co2 and am trying to perfect the installation of my R/T on/off valve.
I am a Mold Maker and therefore have no worries regarding the machining aspect of this question. (not meant to be arrogant-just removing any concerns)
All input is welcome, so long as it does not try to get me to ever sell my mag or references my Mom in any way.
Thanks
I have checked my A.I.R. valve hole alignment from the regulator to the main body and found them to be misaligned by a little more than 1/3 of a turn when the valve is assembled and the logo etching matches up.
Should I:
1)Leave it alone?
OR
2) Drill a second hole in the regulator that aligns with the main body hole?
This to improve flow and reduce shootdown.
I run Co2 and am trying to perfect the installation of my R/T on/off valve.
I am a Mold Maker and therefore have no worries regarding the machining aspect of this question. (not meant to be arrogant-just removing any concerns)
All input is welcome, so long as it does not try to get me to ever sell my mag or references my Mom in any way.
Thanks