View Full Version : Could you charge an emag with...
leloup
05-27-2010, 09:09 AM
Do you think it would be possible to charge an emag with a cordless drill charger? Maybe a pair of gator clips jumping the bridge. Any ideas? Any one try it?
Possible, sure. Probable? Not so much. You're really likely to be putting a very different amperage/voltage in than the battery is expecting.
leloup
05-27-2010, 12:07 PM
What are the amp/volts required for the battery?
Tunaman
05-27-2010, 12:33 PM
Just remember that there are NO MORE EMAG BOARDS. I dont recommend it.
leloup
05-28-2010, 09:20 AM
There is no way taht I would connect any power source to the board besides an AGD battery. But, I would connect the battery to something to charge it....
Success! I checked the volts and amps of the cordless drill charger, and they are slightly less, volt wise, and much less amps wise. I let it charge for about 45min, and now I have a good charge on my battery. It is an older battery, so I wasn't worried about damaging it (covered in rust from previous owner).
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.