AM/MM Rail/sear vs. emag/RT bearing sear and rail, with an x valve...

[MoeMag]

Just thinking while playing today... My x valve has never been very reactive, was wondering if using an AM/MM sear with the drop in pin, might have more "slop" making the RT a little harder to sweet spot?

[Slider30250]

How reactive your X-valve is will depend on A, how much pressure is going into your valve, B, how much friction the Lvl 10 o-rings have, C, how much friction your On/Off assembly o-rings have. A worn sear should make the valve RT easier.

[sjrtk]

I have my X between a minimag and ule RT set ups on a regular basis both sweet spot very cleanly for me. But my Retro valve will barely sweet spot no matter what air pressure i have, and even when it does i can pull faster. I think alot of it is valve to valve and on/off pin length doesn't hurt either.