View Full Version : warp feed to ule warp body install.
kit352
11-29-2010, 09:35 AM
does anyone have a better way of mounting the warp tube to a wapr body other than the 90d elbow? ive been using just the straighttube fitting on it and it works but isnt very stable, it can pop right off easily enough. i just dont want to have to use that hideous elbow.
vf-xx
11-29-2010, 10:04 AM
I use a 90* copper elbow, a clamping no-pro feedneck, and some grip tape.
Might be worthwhile to look through Qloader's accessories.
xero28
11-29-2010, 03:32 PM
Pro-Team Products also makes a 90*.
http://www.proteamdirect.com/warfeedad.html
But I'd also try a couple of layers of masking tape over the feedneck to get a tighter fit with your straight connector.
sjrtk
11-29-2010, 03:37 PM
I just put a layer of electrical tape on the straight conector and popped it on. Has held up to the 1 direct hit it took and prolly 2 cases of paint through it. The Q loader 90* adapter also works just remember to get the adapter to hose adapter as well or the hose won't really work.
kit352
11-29-2010, 07:34 PM
I was thinking about the tape but wanted to see if anyone had a better way. I think the main issue is that straight tube adaptor itself has a very small clamping area compared to its tube side. basically it only fits on a small part of the warp body tube and leaves about a 1/2in of it exposed. ill get some pics up and show what i mean.
maniacmechanic
11-29-2010, 07:55 PM
Come on guys this thread needs pic's ;;
http://i103.photobucket.com/albums/m156/maniacmechanic59/markers/HyperWarp003.jpg
http://i103.photobucket.com/albums/m156/maniacmechanic59/markers/CamoX001.jpg
http://i103.photobucket.com/albums/m156/maniacmechanic59/markers/guns002.jpg
http://i103.photobucket.com/albums/m156/maniacmechanic59/markers/guns005.jpg
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.