warp feed to ule warp body install.

[kit352]

does anyone have a better way of mounting the warp tube to a wapr body other than the 90d elbow? ive been using just the straighttube fitting on it and it works but isnt very stable, it can pop right off easily enough. i just dont want to have to use that hideous elbow.

[vf-xx]

I use a 90* copper elbow, a clamping no-pro feedneck, and some grip tape.

[Newt]

Might be worthwhile to look through Qloader's accessories.

[xero28]

Pro-Team Products also makes a 90*.

http://www.proteamdirect.com/warfeedad.html

But I'd also try a couple of layers of masking tape over the feedneck to get a tighter fit with your straight connector.

[sjrtk]

I just put a layer of electrical tape on the straight conector and popped it on. Has held up to the 1 direct hit it took and prolly 2 cases of paint through it. The Q loader 90* adapter also works just remember to get the adapter to hose adapter as well or the hose won't really work.

[kit352]

I was thinking about the tape but wanted to see if anyone had a better way. I think the main issue is that straight tube adaptor itself has a very small clamping area compared to its tube side. basically it only fits on a small part of the warp body tube and leaves about a 1/2in of it exposed. ill get some pics up and show what i mean.

[maniacmechanic]

Come on guys this thread needs pic's ;;

http://i103.photobucket.com/albums/m156/maniacmechanic59/markers/HyperWarp003.jpg

http://i103.photobucket.com/albums/m156/maniacmechanic59/markers/CamoX001.jpg

http://i103.photobucket.com/albums/m156/maniacmechanic59/markers/guns002.jpg

http://i103.photobucket.com/albums/m156/maniacmechanic59/markers/guns005.jpg