View Full Version : Xmag question
mark cody
02-15-2011, 06:40 PM
Are the boards in the xmag the same as emag boards? I have an xmag with a morlock board in it and I would like to replace it with a stock board to run xmod. Any help on this would be appreciated.
correia3
02-15-2011, 06:46 PM
Yes. It should be an easy swap.
Tunaman
02-15-2011, 06:53 PM
Its not going to be an easy swap if they cut all the leads to install the morlock. The hard part is going to be finding a board...
mark cody
02-15-2011, 08:03 PM
The search for a board has begun.
correia3
02-15-2011, 10:26 PM
Its not going to be an easy swap if they cut all the leads to install the morlock. The hard part is going to be finding a board...
Good point. I figured you would be buying all the internals together. My bad...
divil
02-15-2011, 10:41 PM
im kinda lost why would someone change from a morlock board to a stock board to run xmod and spending a lot of money.
For the same reason why someone would want to spend a lot of money change from a stock E-Mag board to a Morlock...Cause he can :D
mark cody
02-21-2011, 10:52 PM
So if I pick up some emag lowers I can take the internals put them in the xmag and have xmod installed? with the xmod would i still need the ace board?
correia3
02-21-2011, 11:18 PM
Yes. The parts swap right over. You don't need ACE for XMod.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.