stircrazzzy
05-01-2011, 07:40 AM
So, I have the sear assembly in the micromag body. Are there supposed to be washers or something to hold it in the center? It is very flimsy and bounces around like crazy. It seems as though it should be in the middle, held with washers or springs or something...?
Also, I have an M90 frame on the micro body. The front screw holding the frame to the body seems too long...it isn't bottomed out when I screw it in but it hits the rotating breech in the body. Is there a different screw that I'm supposed to be using? Right now I have washers in there to let it bottom out and it looks like garbage.
Thanks!
Also, I have an M90 frame on the micro body. The front screw holding the frame to the body seems too long...it isn't bottomed out when I screw it in but it hits the rotating breech in the body. Is there a different screw that I'm supposed to be using? Right now I have washers in there to let it bottom out and it looks like garbage.
Thanks!