PDA

View Full Version : Will this work ???


Courgar Hunter
05-07-2011, 01:15 AM
So I bought a X valve and level 10 off of ebay and package was delivered and someone decided to walk off with it and I'm fighting to get it resolved but my question is.

Will a Classic or standard valve work with the Emag lowers but just in mechanical mode ? I'm out of air to try this and I can't seem to find the info I am looking for maybe I am just looking to hard
MoeMag
05-07-2011, 01:22 AM
So I bought a X valve and level 10 off of ebay and package was delivered and someone decided to walk off with it and I'm fighting to get it resolved but my question is.

Will a Classic or standard valve work with the Emag lowers but just in mechanical mode ? I'm out of air to try this and I can't seem to find the info I am looking for maybe I am just looking to hard

Yeah. It should. Once upon a time I put a ULT in a classic valve once and ran it in an Emag just to see if it would work. Don't suggest trying it... but it worked.
Sumthinwicked
05-07-2011, 08:04 AM
works fine if you dont shoot faster than 8 bps the air valve is made for 8 a second faster and ur cutting into the pressure to much for mech it would be fine .... ;)
SockMonkey
05-07-2011, 05:48 PM
I am quite sure air valves are good up to like 13bps. I know they can go better then 8..
Sumthinwicked
05-07-2011, 09:01 PM
they can but they will start lossing power why push it can u dodge one inch apart out the barrel its hard :P
guseppe16
05-07-2011, 09:10 PM
Will the classic on/off cause wear on the Emag solenoid? The trigger pull weight is significantly higher.
unived micindev
08-16-2011, 05:58 PM
so, emag lowers works just fine with classic valve in e-mode? What about classic valve with rt on/off?
leloup
08-16-2011, 07:42 PM
My classic has an rt on/off. Should be fine with emag lowers.
Tunaman
08-16-2011, 07:49 PM
The pin will be too long. You will need a .712
unived micindev
08-17-2011, 08:59 AM
do you have those pins, tuna? I will need at least two of them.
Ando
08-17-2011, 11:47 AM
Hmm...Classic valve with RT on/off with .712 pin...Don't see why it wont work. I've never had luck with the RT on/off in classics. Just never worked right for me.
athomas
08-19-2011, 04:36 PM
The classic valve will work fine in the emag as long as you use the emag on-off assembly with the shorter 0.712" pin. The classic valve will cycle fine up to about 16bps which is fine for most users. Most fields don't allow over 15bps anyway.
tbaggin
08-19-2011, 09:51 PM
J, where are you ahving this shipped to?