PDA

View Full Version : Warp bodies/rails



OPBN
05-13-2011, 08:59 AM
Do only RT/Emag rails have to be cut in order to accomodate a warp ule body? looking at builidng a warped setup and really hate the idea of cutting into any of the rails that I have.

Smoothice
05-13-2011, 09:12 AM
You need to cut down am/mm rails as well.

OPBN
05-13-2011, 01:41 PM
Well that sucks.

guseppe16
05-13-2011, 01:47 PM
Will it be warp left or right?

bumbabeef
05-13-2011, 01:53 PM
I have a emag rail thats cut for a warp left body pm me if interested

C_losjoker
05-13-2011, 04:10 PM
Instead of doing a cut. You can shave both sides of the rail all the way down the length of the rail on both sides. That way you can do left or right warp and if you use center feed you won't have that funky notch in the middle. I have seen one done like this and looks really good. I have a warp and I will be getting that done to it.

Smoothice
05-13-2011, 04:32 PM
I'm willing to bet you could also shave enough off the body itself to possibly clear the rail. Just a thought.

hill160881
05-14-2011, 12:00 AM
^^^I would look into this^^^

p8ntbal4me
05-14-2011, 05:15 AM
The Alpha rail by Logic Paintball and one other had side milling design that allowed the use of a warp feed body without additional milling to the rail.

C_losjoker
05-14-2011, 12:46 PM
Shave the body. I thought those were thin already. I have to check mine out. The thing to consider is if you sell or part this. A milled rail will sell a body might not.

Smoothice
05-14-2011, 04:33 PM
Shave the body. I thought those were thin already. I have to check mine out. The thing to consider is if you sell or part this. A milled rail will sell a body might not.
The warp body has some extra meat below the feedtube.

OPBN
05-16-2011, 07:32 AM
Still waiting for the warp to arrive, but think I may just try it initially on a vert feed body with an adapter to see if I even like it. If so, I'll go from there. Thanks for the input.