Warp bodies/rails

[OPBN]

Do only RT/Emag rails have to be cut in order to accomodate a warp ule body? looking at builidng a warped setup and really hate the idea of cutting into any of the rails that I have.

[Smoothice]

You need to cut down am/mm rails as well.

[OPBN]

Well that sucks.

[guseppe16]

Will it be warp left or right?

[bumbabeef]

I have a emag rail thats cut for a warp left body pm me if interested

[C_losjoker]

Instead of doing a cut. You can shave both sides of the rail all the way down the length of the rail on both sides. That way you can do left or right warp and if you use center feed you won't have that funky notch in the middle. I have seen one done like this and looks really good. I have a warp and I will be getting that done to it.

[Smoothice]

I'm willing to bet you could also shave enough off the body itself to possibly clear the rail. Just a thought.

[hill160881]

^^^I would look into this^^^

[p8ntbal4me]

The Alpha rail by Logic Paintball and one other had side milling design that allowed the use of a warp feed body without additional milling to the rail.

[C_losjoker]

Shave the body. I thought those were thin already. I have to check mine out. The thing to consider is if you sell or part this. A milled rail will sell a body might not.

[Smoothice]

Shave the body. I thought those were thin already. I have to check mine out. The thing to consider is if you sell or part this. A milled rail will sell a body might not.
The warp body has some extra meat below the feedtube.

[OPBN]

Still waiting for the warp to arrive, but think I may just try it initially on a vert feed body with an adapter to see if I even like it. If so, I'll go from there. Thanks for the input.