switching ULT on/off for RT on/off in X Valve

[gmonster88]

Hey AO,

I have my first "issue" with my mag and it is my fault, I have a ULE RT Custom with the X valve and LVL 10.

Anyways I removed the ULT on/off and replaced it with the RT on off from the mag smith, I gas up the marker and it leaks out the bolt. weird.

I take the on off out and turn it around 180* and it gasses up, no leak. Sweet! except I pull the trigger and it leaks down the barrel

I was getting bolt stick and the bolt was not catching on the sear, Im thinking it was because I only had 2000psi in my tank but I digress.


any suggestions or comments? Much appreciated! Thanks
Edit: I also could not re- install my ULT on/off because the #23 oring was wedged On top of the valve but the rt on off slides in fine

[hill160881]

Make sure the two halves of the on off are totally screwed together then reinstall it.

[Ando]

I take the on off out and turn it around 180* and it gasses up, no leak. Sweet! except I pull the trigger and it leaks down the barrel

There's no way you can 180* a RT on/off

[gmonster88]

I think you mis understood what I did, I rotated the on off 180* I did not put it in upside-down. ;)

[Hobbez]

Sounds like you need to replace the o-rings on that on-off

[Ando]

I think you mis understood what I did, I rotated the on off 180* I did not put it in upside-down. ;)
:rolleyes: :rolleyes: :rolleyes:

Carry on. Def change out the orings.

[gmonster88]

Installed a thicker oring on my detent, problem solved :headbang:

Thanks for all your help!