devolumizing a seal automag dump chamber

[cockerpunk]

any good ideas?

how hard is it crack the welds?

[BigEvil]

Talk to Loguzzzzzz. He does it effortlessly.

[StygShore]

Sumpin with a chuck, a thin blade, and safety glasses should do the trick.


Styg

[going_home]

http://www.games-workshop.com/MEDIA_CustomProductCatalog/m1440564_99120115001_DaemonsSoulGrinderMain_445x31 9.jpg


:ninja:

[y0da900]

http://automags.org/forums/showthread.php?t=257871

A few different disassembly options in there - looks relatively simple. I don't think all of the inserts I made for Hill have been spoken for yet, shoot him a message if you want to try one.

[KurtPB]

GW always has the right tools for the job.

[cockerpunk]

thanks guys ... fun stuff comming up ... oh fun stuff.

[BigEvil]

thanks guys ... fun stuff comming up ... oh fun stuff.

Looking forward to seeing it. However, unless you have an entirely new bolt and powertube system up your sleeve, then its probably already been done :)

[hill160881]

Thats what Im hoping. The small diameter of the powertube what is keeping the operating pressure requirements so high.

[BigEvil]

Thats what Im hoping. The small diameter of the powertube what is keeping the operating pressure requirements so high.


Bingo. About time someone said it.

[cockerpunk]

Looking forward to seeing it. However, unless you have an entirely new bolt and powertube system up your sleeve, then its probably already been done :)

no, no it most certainly has not.

[/evil genius laughter]

[y0da900]

I was assuming you were trying to get an FN down to field usable velocities.

[BigEvil]

I was assuming you were trying to get an FN down to field usable velocities.

What fun is that?