OPBN
12-29-2011, 01:59 PM
Opinions are subjective, but wondering others thoughts. I have a ULE frame that for some reason, someone, decided to drill a hole in the front drivers side in front of the trigger, as well as another horizontally through the front of the area between the inner and outer frame. Trying to come up with some sort of solution and I was thinking of something along the lines of this:
http://i307.photobucket.com/albums/nn308/oldpbnoob/emagtriggermillout01.jpg
This is not the actual frame, but another that I have doctored using MSPaint. I know my skills suck, but personally I kind of like the overall look. I also think it will work better with gloves.
The opinion part is whether anyone thinks this will dramtically reduce the value of the frame? I figure it already has two holes in it, and I think this actually looks better. Also, since I am planning on a one offish ano scheme, it most likely wont be seperated from the rest of the marker.... Thoughts?
I'm thinking if done properly and by a professional, it should turn out pretty nice.
http://i307.photobucket.com/albums/nn308/oldpbnoob/emagtriggermillout01.jpg
This is not the actual frame, but another that I have doctored using MSPaint. I know my skills suck, but personally I kind of like the overall look. I also think it will work better with gloves.
The opinion part is whether anyone thinks this will dramtically reduce the value of the frame? I figure it already has two holes in it, and I think this actually looks better. Also, since I am planning on a one offish ano scheme, it most likely wont be seperated from the rest of the marker.... Thoughts?
I'm thinking if done properly and by a professional, it should turn out pretty nice.