Hopper for Xmag

[maverick13]

Hello,

I need your help !

I just recieved the Euro Xmag I bought.

My rotor doesn't go in the feedneck.

Could you tell me what hopper you are using on your Xmags ?

Thanks

[Loguzzzzzz]

Some have had the feedneck modified to have a clamping feedneck added. Back in the day some would sand the feed tube on their hopper until it fit inside the feedneck. I have both.

I am not aware of anything that will just fit out of the box though.

[Fred]

Warp it. :ninja:

[TwilightG]

I used to use a VLocity Jr. on my old X-Mag. It was a perfect fit for the stock feedneck. If anything, it was slightly loose but I never had issues with it falling off.

Be careful with the Rotor. Lornecash accidentally pulled his feedneck out of his magma X-Mag back @ TB3 when trying to remove a very snug rotor.

[maverick13]

Thank guys, this will help

[BigEvil]

Of you can just send the breech to me for a CCM feedneck mod and never have to worry about it again :eek:

[Redic]

I took a pair of locking vice grips and shaved a little of the.feed neck off to fit mine

[zondo]

Of you can just send the breech to me for a CCM feedneck mod and never have to worry about it again :eek:

I will probably leave my breach with you...

:ninja:

[BigEvil]

I will probably leave my breach with you...

:ninja:

What color do you want? I will order it and I can do it for you while you are here.

[Apollo816]

i had the same prob with both my xmags and ptp micromag..i actually had 2 rotors so i shaved one of the knecks down so it fit snug. ...now that rotors are over 200 unless you have an extra one i wouldnt suggest it though lol