Need fast x-valve help

[leloup]

When things aren't broken, I need to learn not to mess with them. My warp mag is leaking out of the side hole in the valve (left side). I didn't even know the hole existed until air was coming out from it. I checked the power tube dump chamber (is that what it is called?) and put a new oring on it just in case. I need ideas. Planned on using it friday night.

[stimpysan]

remove your regulator valve pin. On the bottom will be two orings and a plastic spacer. Replace the orings and spacer, lube and re-install and you should be good to go. I've had it happen 3 or 4 times on older x-valves and it fixed it every time.

[OPBN]

Also try just cleaning those o-rings. Seems like even small dirt particles in that area will cause leaks.

[leloup]

By reg valve pin, do you mean on off pin?

[my automag]

By reg valve pin, do you mean on off pin?

No, it's not the on/off pin. Regulator valve pin assembley.

You can check this out, especialy picture in...
Post #4 ... PART # 30.
http://www.automags.org/forums/showthread.php?t=255279&highlight=regulator+valve+pin

D.K. :cheers:

[leloup]

oddly enough, I cleaned the one off, and it no longer leaks, but now it doesn't fire (bolt stick?).

[athomas]

Did you change the powertube oring? If you did, then you need to retune your level 10 bolt system.