Use of trigger stops

[Carnage reigns]

HAs anyone here used them long term? Have you had any problems with your valve, spring, etc since you started using them?

[Spider-TW]

As long as you maintain the gap behind the trigger with the trigger-rod you can use them just fine. That usually means that you can only use an over-travel stop, and for that you should give it a little extra play for reliability and sear clearance.

You also will likely need to push your trigger-rod back by hand (with something small) before trying to extract your valve, since the on/off pin will be dangling down into the body and the trigger can't push it up.

Take a look at your over-travel first though. Some frame/triggers don't have a lot in the first place. If you have a gap behind the trigger that's a little large, the single CF frames don't have much over-travel to start with.