Skiddz
06-26-2012, 01:05 AM
I just pulled my Tac-one out from retirement after being sponsored to do a run with this weekend. I had a ULT installed in it a few years back when it was my main setup.
I don't remember at the time it shooting below 270 but this weekend I installed my barrel and took it to the chrono. I was hitting average 200, some shots 194...
I decided to take it out anyways. I had a few times where it refused to even shoot and took a few pulls to get shots off.
I haven't fooled around with it, nor have I been in the game of mags in a quite some time to even begin to remember how to go about this problem. Should I try replacing the drive spring with a tighter one first or what? The automag air tech my team is sponsored by left the field I was at before I could run it to him.
Any ideas?
I don't remember at the time it shooting below 270 but this weekend I installed my barrel and took it to the chrono. I was hitting average 200, some shots 194...
I decided to take it out anyways. I had a few times where it refused to even shoot and took a few pulls to get shots off.
I haven't fooled around with it, nor have I been in the game of mags in a quite some time to even begin to remember how to go about this problem. Should I try replacing the drive spring with a tighter one first or what? The automag air tech my team is sponsored by left the field I was at before I could run it to him.
Any ideas?