Trigger Pin out of Z Grip?

[djinnform]

How do I get the trigger pin out of the Z Grip, for annodizing purposes, without destroying it?

Thank you.

[TimmyJay]

I just did this yesterday. I used a hex key and a hammer on a section of carpet. Just have to make sure you hammer the right direction. 1 side of the pin is smooth and the other side is rough with crimping.

[OPBN]

Correct way is to press it out. Homegrown way is to use a nail set and suspend the frame between two blocks of wood. If you do not have a fine enough point nail set, you can use a sturdy nail. Try blunting down the tip of the nail to help keep it from skittering across the frame. Make sure you are set before each strike and stay vertical. You also need to know which side of the frame the pin comes out of.