xvalve removal first mag

[Njt11]

SORRY in advance for the dumb question. I am completely new to the AO community. I recently purchased my first AGD product an xmag and I have searched all over but I can't figure out how to get the valve out of the marker. I removed the the screw from the back of the marker and the valve will not come out. Does the trigger frame have to be completely removed or am I just missing something. I normally wouldn't post this but I have searched and I've come up with nothing.

[BTAutoMag]

pull the trigger, the on/off pin is extended

[Njt11]

I tried the valve will not come out.

[DarkApollo]

Push in a little, twist to the right, should slide out.
There is a little tiny tab at the bottom that goes into a groove and twists to lock it in place.

[Njt11]

It must have known you were on the case I went down there ready to try your advice took the screw out of the back and the valve all but jumped out lol so thank you very much. :clap:

[Flatliner333]

Watcha doin to it ?

[890SHAWN]

Watcha doin to it ?
Good to hear about your first mag. Do you have pictures of your prize?