View Full Version : Need an E/X Mag Schematic
Dark Side
04-30-2013, 03:56 PM
I need a schematic for the board (yes I have searched). I picked up a couple of PBX Viking frames which use a HES to fire the marker. The very same part number which our Mags use and if I ever want to get these things working, I need the wiring diagram to get there.
splat15k
04-30-2013, 04:33 PM
I am sure p8ntbal4me would be able to point you in the right direction if nobody else offers a quick response.
athomas
05-03-2013, 05:50 AM
I can't find my HES data sheets, but I think the pinout is:
Pin 1 = power
Pin 2 = ground
Pin 3 = switched output
Emag pinouts (not fully complete)
Atmel AT90S2313-4SC with connection points labled
Pin Name Connection
1 RESET CN4 pin 1
2 (RXD) PD0 Stamp pin 7
3 (TXD) PD1 Stamp pin 8
4 XTAL2
5 XTAL1
6 (INT0) PD2 Trigger input; stamp pin 9
7 (INT1) PD3 To MOSFET U3 (solenoid)
8 (T0) PD4 Switch PB2, stamp pin 10
9 (T1) PD5 Switch PB1, stamp pin 11
10 GND
11 PD6 (ICP) HCMS CE
12 PB0 (AIN0)
13 PB1 (AIN1)
14 PB2 HCMS clock
15 PB3 (OC1) HCMS data in
16 PB4 HCMS RS
17 PB5 (MOSI) CN4 pin 4
18 PB6 (MISO) CN4 pin 3
19 PB7 (SCK) CN4 pin 2 (burst jumper)
20 Vcc
CN4 pin 1 RESET
CN4 pin 2 SCK
CN4 pin 3 MISO
CN4 pin 4 MOSI
CN4 pin 5 GND
CN2 pin 1
CN2 pin 2
CN2 pin 3 Vcc
Dark Side
05-05-2013, 08:41 AM
I can't find my HES data sheets, but I think the pinout is:
Pin 1 = power
Pin 2 = ground
Pin 3 = switched output
That's exactly what I needed. Thanks.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.