PDA

View Full Version : Simple X-mag Question


neogp
05-10-2013, 01:10 PM
Is the feedneck threaded into the stock block or pressed?

I removed the set screws (one AM and one MM..:confused:)

figuring if its threaded has a wee bit O'loctite. warmed her up with hot water...87792

87793

no gots..:(


Help?!
splat15k
05-10-2013, 01:26 PM
It is pressed in for sure.
Dark Side
05-10-2013, 03:31 PM
To my knowledge, all Xmag breeches are pressed in.
C_losjoker
05-10-2013, 10:14 PM
What set screws, only automag that I can think of with set screws is the micromag?
splat15k
05-10-2013, 10:38 PM
What set screws, only automag that I can think of with set screws is the micromag?

The x-mag modules have two set screws that clamp down on the feedneck for extra insurance. They cannot be seen unless you remove the module and look just above the breach hole (one on each side).