View Full Version : max-flo reg help
Chencho
07-25-2013, 09:16 AM
hi, just quick questions about the SmartParts MaxFlo regulator (Tank reg)
whats its min/max output pressure?
difference between 4.5k and 3k? (other than the air capacity...)
any other tank can be used with it, or need a specific tank?
tnx, the faster the better... my mag is asking for a adj. regulator :shooting:
just want to hit maximum tuning to make it as silent as possible, and also for RT (by changing output pressure).
athomas
07-26-2013, 06:07 AM
Any tank will work. The threads are standard threading.
The min/max output pressure depends on the spring kit and piston that is installed. There is a high output version and a low output version. The high output version works great for mags, but the low output version won't allow you to get to high enough pressure. Its not just a matter of changing the piston and spring. The back section is changed as well, to accept the smaller diameter piston for high pressure operation.
I don't think there is any difference between the 3k and 4.5k versions other than the safety pressure reliefs.
Chencho
07-26-2013, 08:07 AM
The min/max output pressure depends on the spring kit and piston that is installed. There is a high output version and a low output version.
theres a high and a low version for all 3 versions, right?
sorry for bugging to much, just want to make sure I ask the right questions before buying one.
thanks :D :bounce:
athomas
07-26-2013, 01:43 PM
Check this out:
http://www.zdspb.com/tech/mguide/regs/comparison.html
http://www.zdspb.com/tech/mguide/regs/faq.html
Chencho
07-27-2013, 08:08 AM
Check this out:
http://www.zdspb.com/tech/mguide/regs/comparison.html
http://www.zdspb.com/tech/mguide/regs/faq.html
thanks!
thank you guys!:headbang::clap::headbang::clap:
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.