X-valve venting from side little hole, HELP!

[Chencho]

frustration guys... bought an X-valve from a friend and its been leaking since I aired it up :tard:

Its leaking from the side little hole.

do I need a rebuild kit? where can it be found?

thanks maggers, I mean... this is my super damn accurate marker, and already miss her!:(

[Freedy500]

Oil goes a long way....

[Patron God of Pirates]

frustration guys... bought an X-valve from a friend and its been leaking since I aired it up :tard:

Its leaking from the side little hole.

do I need a rebuild kit? where can it be found?

thanks maggers, I mean... this is my super damn accurate marker, and already miss her!:(

One of the two o rings on the reg pin assembly.

[Chencho]

Oil goes a long way....

tried, nothing :(

took it apart, cleaned, oiled, still leaks

[Chencho]

One of the two o rings on the reg pin assembly.

where can they be bought? or a whole kit?

[OPBN]

I know you said you cleaned and oiled it but usually dirt is the culprit. Try again or buy a rebuild kit. The AGD store has them as does Tunamart.

[Chencho]

I know you said you cleaned and oiled it but usually dirt is the culprit. Try again or buy a rebuild kit. The AGD store has them as does Tunamart.

alright, will check and get one on the way asap. thanks!

[Chencho]

alright, will check and get one on the way asap. thanks!

Is it all here?

"Kit Includes:

2 Power Tube O-rings
1 Reg. Piston O-ring
3 RT Reg. Seat O-rings
1 RT Reg. Body O-ring
1 RT/Emag Bumper (yes, it's different)
2 RT On/Off Small O-rings
4 RT Reg. Valve Pin O-rings
1 RT Reg. Valve Pin Spacer
2 Foamies
5 L10 Carrier OD O-rings
5 L10 Shims .010
2 L10 Back-up Washers
1 Reg Valve Pin C-Clip"

[halB]

alright, will check and get one on the way asap. thanks!

Had the same problem.

There are two vent holes: One on the reg, and one closer to the feedneck that is on the valve side of the body.

If it is the latter, there is a problem with your 006 polyurethane o ring on the valve pin assembly.

No, you cannot use butyl nitrate, nor can use vitron, nor teflon. None of those work. Only polyurethane. The best way to get it is a rebuild kit. 006 polyurethane o rings cost like 15 shipped for 10 or so. The rebuild kit costs 24 and shipping from tunaman (email or PM him, the cart for his shop doesn't work). the kit comes with so much else it's smarter to just get the kit.

I know. I resisted getting the kit. I tried so many other things. But frankly, unless you have a local source for polyurethane o rings (highly doubtful, I live in an international city and the only source is from companies that supply products for building jet engines :P ) then you should just suck it up and get the rebuild kit.

Been there. Done that. Get the kit.

[Chencho]

alright, will get the kit then. will get back if any help is needed :hail: