View Full Version : Xvalve and Classic o-ring size chart?
Is there a document or URL I can access to see the farious o-ring sizes and durometer? There's a GBS store a block away from my place and it would be great to have that info handy to build myself an o-ring rebuild kit.
Justus
12-16-2013, 10:17 AM
Best I can do for ya (copied/pasted from MCB):
Classic Valve (for Automag 68 and Mini-Mag; 1 rebuild)
4 Power Tube O-rings 010
4 Teflon O-rings 006
2 Barrel O-rings 018
2 Reg. Piston O-rings 012
1 Reg. Body O-ring 116
RT Classic (1 rebuild)
3 Field Strip Banjo O-rings 009
3 Barrel O-rings 018
2 Power Tube O-rings 010
1 Reg. Piston O-ring 012
2 Reg. Seat O-rings 008
1 Reg. Body O-ring 018
2 RT On/Off Small O-rings 004
4 RT Reg. Valve Pin O-rings 006
Level 10 Bolt (1 install)
2 Carrier O-rings 008
1 Power Tube Tip O-ring M1.78X7.94?!? (I need to confirm this. Is this the same Size as would be found on other mag valve tips? I had a dead one in an old Mini-mag that I couldn't figure out the size for, but I replaced the Level 7 with a Level 10 and didn't need it anymore.)
Power Tube (on/off bottom) O-rings - 010
Reg. Piston O-ring - 012
Reg. Seat O-rings - 008
Reg. Body O-ring - 017
RT On/Off Small O-rings - 004
Reg. Valve Pin O-rings - 006
L10 Carrier o-ring - 008
Reg. nut (barrel) o-ring - 017 or 018
Teflon on/off o-ring - 006 (PTFE)
Emag Quad O-ring - 006 (0.070" width, Buna-N)
I believe all are 90D Urethane unless specified.
Wow, awesome stuff, thanks!
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.