Warp mods?

[p8ntballa]

I did a search for a little bit, but didnt come up with anything good. Does anyone know where i can get directions for putting a LED light an a on/off switch on a warp?

[lopxtc]

If you goto
http://www.pettypb.com/timiwarp.html

Its mostly about wiring an Intimidator to the warp, but at the bottom it has the dual 9v battery mod and on/off switch mod. Very very easy to do with a cost of about $20.00 for everything.

Aaron

[email protected] if you have any questions ...

[p8ntballa]

sweeeet, anyone know how to do the light?

[Chris]

Wire it inline with your on/off switch.

-Chris

[p8ntballa]

any place with pics?

[p8ntballa]

any place with pics of the light and directions. i dont trust myself without directions.

[Pand0ra]

Buy a LED of the color you want. Solder the cathode to the ground (the - of the battery). The cathode is in general the lead where there's a flat on the led.
Solder on the other side a resistor of 1,5k.
The other side of the resistor goes to the + (after the switch if you want the led to light when the switch is on).

That's all. If the led doesn't lit, it means you've reversed the connections. Just swap them.

@++