View Full Version : Pneumatic trigger, ULE, ULT, X-valve, Lvl 10
Mic0157
05-21-2014, 04:05 PM
That's pretty much it. I've had his marker for a year, and don't use it. I had the sear assembly replaced and it shoots like a dream. Just add a couple of drops of oil, some air, and get at it. Any idea on value?
lobo_fuerte
05-22-2014, 10:55 AM
Pictures help also if you part the marker you tend to get more then selling it as a whole.
Pictures help also if you part the marker you tend to get more then selling it as a whole.
^^^^ Pictures help quite a bit. There is a BIG difference in value between a hacked up, home job, jerry rigged, Pneu'd Benchmark frame and a nicely done, sleeper pnued M90 frame. Condition of the parts helps as well. A cherry X valve with bright lazering and no visible wear with all the replacement parts is going to sell for more than a ragged out X that is faded from going through the dishwasher and comes with no carriers etc.
audioSLAVE
05-22-2014, 11:06 AM
^^^^ Pictures help quite a bit. There is a BIG difference in value between a hacked up, home job, jerry rigged, Pneu'd Benchmark frame and a nicely done, sleeper pnued M90 frame. Condition of the parts helps as well. A cherry X valve with bright lazering and no visible wear with all the replacement parts is going to sell for more than a ragged out X that is faded from going through the dishwasher and comes with no carriers etc.
Lol, dishwasher. It's funny because it's true. DIY Pewter Anodizing.
Lol, dishwasher. It's funny because it's true. DIY Pewter Anodizing.
I know, it's why I remember it. lol.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.