My barrel is stuck!

[DBC]

I have an Automag TAC-1 with a older Whisper carbon fiber barrel and it is stuck. I have had this set-up for years and never had a problem because I was careful not to screw the barrel in too tight. I lent my gun and barrel to someone and it got screwed in too hard.

How do I get it undone? I sprayed it with WD-40 and then heated the body to loosen things up, but the carbon fiber part of the barrel started to separate from the aluminum threads.

Has anyone solved this problem before?

[Mole1119]

I would try a strap wrench to get a better grip, hopefully they didn't cross thread it, I am not sure how easy that is to do.

[Spider-TW]

That happens.

You might try the FIGG...

http://www.mcarterbrown.com/forums/1797042-post15.html

[athomas]

Heat the body and then put the barrel in cold water. The combination of the two extreme temperatures will give better separation of the two diameters. A good strap wrench or piece of rubber to get a grip on the aluminum back section will help alot too.