13Bps Hyperframe

[*c-ro*]

So i recently acquired a couple of Center Flag Hyperframes. I am assuming that the clapper solenoid only actuates when the gun is aired up and the valve pin is pushing against it ??? The power up and read fine, and when i push the clapper noid pin in, it actuates, but not unless I'm pushing it in .. this is correct ??? And how much do these go for ???

[*c-ro*]

No one knows the value of these ???

[Nobody]

$50ish maybe? They rarely come up now. The downside is that they are slow for even a tuned Xvalve. If you don't have the Centerflag on/off oin or top(i forget which) they havesome problems.

[OPBN]

$50 is pretty low. Most have been selling for $100-125+ from what I remember. Chrome ones sell for less than the black.

[Sk8ermog]

Yeah hyperframes should go for around $80-175 depending on upgrades like board, trigger and grips.

So how many did you get? I just got an order in of used centerflag boards that I need to test out.

http://www.pbase.com/rgunn4/image/159410074

If you need a replacement board for any of your frames then let me know. I am sure some of the boards should be 20bps boards.

And they are actually pretty fast if you have an upgraded microswitch from Luke Customs and combine it with his trigger. They can be very walkable. I've played about 3-4 tourneys with one and kept up with the shockers and other guns back in the day.

Feel free to PM me any questions you have about them. I know a little something about hyperframes. ;)

http://www.pbase.com/rgunn4/hyperframes

[*c-ro*]

i have two of them, the boards and all seem to work fine. They are both stock from what i can see .. i think i only have 1 with a sear .. do they take special sears or a normal automag sear ??

[Sk8ermog]

Normal AGD sears but you take off the bottom half so they are just the top part.

[*c-ro*]

ok, thanks