View Full Version : Best practice for attaching threaded feedneck?
SpyderBoy
04-17-2015, 11:52 AM
Hey all! What's the consensus on the best practice for attaching your threaded feedneck? Or is there one? I'm wondering if I should locktite or just friction fit or what? I don't want it to be totally permanent, but very secure.
ScottyBeans
04-17-2015, 12:22 PM
I'd go with good old fashioned friction. Never had issues besides being a bit too hard to unscrew, so no need for locktite
Tunaman
04-17-2015, 02:27 PM
Definitely blue Loctite. You don't need much.
BLachance75
04-17-2015, 03:12 PM
I usually use a drop of blue loctite then put it on a hopper and twist it on. You can use the hopper for a little more leverage.
going_home
04-17-2015, 04:22 PM
I just screw it on, put a hopper in it and use the hopper to torque it down.
No thread locker.
;)
SpyderBoy
04-17-2015, 04:47 PM
Nice! Thanks for all the advice. :)
Nobody
04-17-2015, 08:32 PM
Hammer, brute force, impact gun... ;)
A little blue loctite is all you need if its too loose for your liking.
2BAD4U
04-18-2015, 01:22 AM
Hand tite... :cool:
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.