9 volt revvie and intellifeed???

[wimag]

i am picking up my cousins new RT Pro tomorrow and was wondering if anyone knows for sure that you can intellifeed a 9 volt revvie. If so, is the wiring set up the same as a 12 volt revvie?
I wanna install the link to the gripframe for him before i deliver it and just wanna speed up the guesswork before our tournie this weekend. Thanks

[DaosBeoulve]

I intellifed my 9V and it works fine thus far. I used the same set up they used for the 12V(found here--http://www.airgun.com/downloads/eureka3.pdf)

[wimag]

excellent!! thank you, just what i was hoping to hear.

[DaosBeoulve]

Let me know if you have any problems. For instance, when I tried to put the switch in the frame, I had the switch situated two high, and thus the switch was always on, so the hopper would turn even if the eye was covered. Just giving you a head's up if you haven't ever done anything like that before. Good luck:D

[wimag]

Shouldnt be a problem. Rigged my mag up to my 12 volt a while ago, just concerned about the 9 volt wiring. Thanks