My First Mag Project

[BassdudeBTB]

RT Classic
Level 10 Bolt
Doc's AC Thread adapter
15" Lurker Barrel (0.685") with AC Threads
Lapco Mock Suppressor with stuffing to mute barrel porting. Significantly Quieter!
Rail raised for Laser with a custom piece screwed into the top of the stock rail sight.
Q-Loader
AGD Warp Feed adapter
Not sure what type of Drop-Forward is on it.
Datapimp attachment system.
AGD Flatline 4500 (Output set to ~1050 psi), 90ci, 4500psi Ninja tank [New Setup]
On/Off pin trimmed to 0.743"

92391

Setup as of March 2016.

[El Zilcho]

interesting, how do you like the q loader?

[BassdudeBTB]

I'm still tweaking it a bit. I had too much tension on the drive spring so I was getting multiple feeding. Balls were pushing past the detents. The local field paint was a bit small so I'm looking into a smaller bore barrel. Otherwise it's nice! Easy to reload. It's my first Q-loader setup so I'm still learning all the tricks.

[Ragu310]

Cool set up!

[BassdudeBTB]

Thanks! Any advice is always appreciated. I ordered an Eigenbarrel with a few control bores from Lurker. I'm hoping it will tighten up my shot pattern. I also installed my cocker thread adapter from Doc's machine shop and tried it with my CP .685 cocker barrel and it seemed better.

[smallerfreeze]

i know you can fit another drop forward on that bad boy