View Full Version : Halo voltage?
93klauss
03-17-2016, 07:44 AM
So was running a warp with big cell, but I went with a rechargeable battery that puts out 11.1v, 800mah 20-30c discharge... Decided to do the halo mod...
The question is would I also be able to run the halo from the rechargeable battery pack?:confused:
Something like two 9v in parallel..
Thx Guys.
93klauss
03-18-2016, 08:15 AM
To PB nation I go...
athomas
03-18-2016, 12:17 PM
The HALO runs on 9V nominal voltage which is the same as two 9V batteries in parallel. The 11.1V LiPo battery pack should be fine running the halo.
93klauss
03-21-2016, 08:13 AM
To specify,I am talking about a halo2. That might make the world of difference..
So if i Understand this the, 4 double AA battery pack supplies around 6v. So you are saying that the board can handle the 11.1 supplied from the battery pack, without damage?
athomas
03-24-2016, 08:19 PM
^No. The Halo uses 9V. The Halo 2 is a different hopper and uses 6V. Using the 3S 11.1V pack will supply too much voltage. You would need a 2S LiPo pack in place of the 4 AA batteries for use in the Halo 2.
93klauss
03-27-2016, 08:28 PM
Thank you,
It was not adding up, no harm done.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.