View Full Version : Classic Valve On/Off brass top hat Dimensions
renie
12-09-2016, 02:38 PM
has anyone got the dimensions of the brass top hat in the on/off for a Classic valve
I haven't got one to hand to measure and a friend has lost his, so I thought it would be easier just to knock him up one at work.
Any input appreciated
Cheers
Ren
Sandman
12-13-2016, 06:11 PM
On/Off Top (http://www.airgundesigns.com/product-p/000141.htm) <----link to product
They cost $7.00 for new one....probably 100's laying around used for less.
I guarantee you will spend at least $200 in time making one.
If it was A $100 part.....maybe...it might be worth it...
renie
12-14-2016, 02:15 PM
there cheap as chips I know, but being in the UK has its down points when it comes to mag stuff (:
it would take me 5 mins on my collet lathe to make one tbh :) perks of being an engineer :)
only want to get a classic valve back up and running for a friend
Spider-TW
12-14-2016, 02:58 PM
I'll try to remember to dig one out.
captian pinky
12-14-2016, 03:26 PM
Ill take some measurements when i get home today.
renie
12-15-2016, 08:24 AM
Thank you guys appreciate it
Spider-TW
12-15-2016, 09:55 AM
:tard: I had remembered on the way home, but that thought was destroyed when I got there. We have a wedding going on this weekend, chaos reigns. I have hope still.
Spider-TW
12-16-2016, 05:15 PM
Thickness = 0.1865"
Diameter = 0.3715"
ID - 0.1475"
ports (4) = 0.0875"
small diameter/waist = 0.271"
waist height = ~ 0.115" it looks half-circular between the inner and outer diameters, so that would be about right.
renie
12-17-2016, 07:24 AM
Thank you
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.