Emag issue

[PhrostPhreek01]

im having an issue with my emag. the battery is charged i put it on electro mode it shoots once then turns off. i have no idea where to even begin. any help would be much appreciated

[Nobody]

Check the ground. Make aure that it has a good contqct with the frame, i.e. clean off the contact and even scrape the aluminium for the contact.

[BigEvil]

Oh, and check to make sure the trigger magnet is not too close. If it is, the board will act like you are pulling the trigger.

[BigEvil]

PUBLIC SERVICE ANNOUNCEMENT

Do NOT EVER take emag advice from Doug.

[maniacmechanic]

public service announcement

do not ever take emag advice from doug.

lol

[Beemer]

Two mags work just fine when the harness is not plugged in, but as soon as I plug it in one board turns off right away and the other board fires once then turns off. One emag worked just fine prior to switching the harnesses between the guns. Any suggestions as to what it could be?


From this Thread

http://automags.org/forums/showthread.php?273774-EMAG-Hall-Harness-issues&p=2904646#post2904646

Back off the trigger screw a touch. The hes has moved. Then see post 11 in above Thread.

[PhrostPhreek01]

can get it to shoot more than once now after adjusting the connectors, i think its an issue with the magnet like you said. gonna mess with it some more tomorrow. stu[id work messing up my hobby time
thanks for the help guys ill keep you posted on when i break it :)

[PhrostPhreek01]

will do thanks !! ill get it a go in the morning

[PhrostPhreek01]

update! the paper wedge worked. took a few tries but it did the trick, thanks guys!