View Full Version : Any "how to" drill a CP direct mount ASA for sleeper pneumag?
jherr505
09-10-2018, 03:22 PM
Is there a how to anywhere?
thanks
Jason
Tunaman
09-10-2018, 03:37 PM
Send it to Loguzz or Luke.
awo702
09-10-2018, 06:01 PM
I followed Mag79’s “how to” thread hear on AO. I’ve done about 8 of them successfully.
Sent from my iPhone using Tapatalk
awo702
09-10-2018, 06:01 PM
http://www.automags.org/forums/showthread.php?232154-Drilling-a-Direct-Mount-CP-On-Off-For-a-Sleeper-Pneumag
Sent from my iPhone using Tapatalk
jherr505
09-10-2018, 06:49 PM
Thanks. That’s what I’m talking about.
There's not a lot of room for error, if you wind up drilling into the center cavity you will ruin the asa.
awo702
09-10-2018, 08:16 PM
There's not a lot of room for error, if you wind up drilling into the center cavity you will ruin the asa.
This is true. If you have no modding experience, send it to luke. He did a couple for me before I attempted it.
Sent from my iPhone using Tapatalk
knownothingmags
09-10-2018, 08:31 PM
ive done a bunch of these with no issues. i also had access to good equipment to do so.
as luke said not alot of room for error. if you do take the time to do it yourself take your time no need to rush.
Ff33gfd
09-10-2018, 11:43 PM
I have a gloss black CP asa this is already drilled. I'm willing to sell. PM me if interested.
jherr505
09-11-2018, 02:02 PM
Thanks everyone. I have a pretty stout drill press with index capabilities and various jigs v-blocks and such. I'll give it a try.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.